Dieter Schmid's Fine Tools
Angle Driver Drill Tools

Angle Driver Drill Tools

These angled power screwdriver/drill tools are heaven sent for getting into tight corners. Because of the angle, they cannot however rival the precision you can obtain with normal drills and screwdrivers. When drilling, for instance, one often ends up with a lightly egg-shaped hole, which need not be a problem unless you are working to very high tolerances.

COBRA Multi Angle Driver Drill Tool
- made by Star-M/Japan.
This multi-angle screwdriver and drill bit chuck can be adjusted with a hexagonal socket bolt to drive screws or drill holes at any angle. So you can get a grip on the most difficult installations. The multi-angle driver has a standard 1/4 inch (6.35 mm) socket that will take all standard bits. The tool will accept all standard drill bits with a 6.35 mm hexagonal shaft, but they must be at least 50 mm long - the small 25 mm bits are too short to work in the tool.
Delivered with a hex key to adjust the head's angle.
Code 312852CartPrice € 99.90
instructions
Directions for using the Cobra Multi Angle Driver and Drill Tool
  1. Loosen the hexagonal head bolt on the housing.
  2. Turn the housing head to the desired angle.
  3. Re-tighten the bolt to lock in the desired angle. Be careful that the teeth between the two halves of the housing are properly mated before using the tool.
You are here:   Homepage   →   Srewdrivers, Ratchets   →   Angle Driver Drill Tool