Additional information about the carpenter's vise No. 52 without quick adjustment

The vise should be secured with sufficiently large screws on a plate that cannot tip over. Keep in mind that this vise weighs almost 16 kg! We recommend M12 hexagon head screws for the rear holes, which are countersunk from above into the plate. For the front holes (i.e., near the jaw), we recommend 12 mm thick wood screws with hexagon heads, screwed in from below. The heads and nuts of the screws should be equipped with washers. Details see image!

You can easily cover the jaws with wood after assembly if you wish. Holes are provided for this purpose on the jaws.

Assembly Instructions

Mounting surface 230 mm x 130 mm
Hole spacing on the jaw 180 mm
Hole spacing at the back 170 mm
Total length 550 mm
Clamping width 342 mm
Recommended wood thickness 90 mm
Thinner plates can be doubled up at the mounting point!