Dieter Schmid's Fine Tools
Taper Gauge

Taper Gauges

SHINWA Taper Gauge

SHINWA Taper Gauge

A very useful tool especially for bearing work and for gaging slots. Made of stainless steel. This Taper Gauge must be inserted upright with the narrow, 1.2 mm wide edge. On the rear side you find a diameter correction table for inside measurements of pipes.
Total length 148 mm
Thickness/edge width 1.2 mm
Front side:
1 mm to 15 mm in 1/10 mm-steps
Rear side:
Diameter correction table for inside measurements of pipes

Code 310365CartPrice € 10.95

SHINWA Taper Gauge with Metal Case and Clip

SHINWA Taper Gauge with Metal Case

As above with metal case and clip to carry in pocket.
Rear side open

Code 310366CartPrice € 14.95

Taper Gauge for Measuring Clearance, Hole Diameter, and Length

Taper Gauge for Measuring Clearance, Hole Diameter, and Length Taper Gauge for Measuring Clearance, Hole Diameter, and Length

Meßkeil für Spaltmaß und Lochdurchmesser, mit Längenmaß

This two-part taper gauge from SHINWA lets you measure clearance, hole diameter and length with a single instrument. To measure clearance, insert one edge of the taper gauge as far as possible into the space; the scale is at right angles to this edge. This scale is provided twice so that you can insert the gauge from either left or right to read off the clearance on the scale. For measuring hole diameters you insert the instrument into the hole until a graduation mark touches both sides of the hole at which point you can read off the hole diameter. The third scale is used to measure length as you would with a normal steel ruler. Made of rustproof stainless steel.

Picture right: Measuring hole diameter.

Accuracy clearance ±0.05 mm
Accuracy hole diameter ±0.05 mm
Accuracy length ±0.15 mm
Measuring range clearance 1 - 15 mm
Measuring range hole diameter 2 - 15 mm
Measuring range length 0 - 120 mm
Size 144 x 16.3 x 5.5 mm
Weight 25 g
Code 310368CartPrice € 21.90

Determining the clearance:
Messkeil

Place the gauge on one side of the space...

Messkeil

...slide along as far as possible and read off value

SHINWA Taper Gauge

SHINWA Taper Gauge

A very useful tool especially for bearing work and for gaging slots. Made of stainless steel. This Taper Gauge must be inserted upright with the narrow, 1.35 mm wide edge.
Total length 155 mm
Thickness/edge width 1.35 mm
Front side:
15 mm to 30 mm in 1/10 mm-steps

Code 310367CartPrice € 16.95

STARRETT Taper Gauge

STARRETT Taper Gauge

This wedge style Taper Gauge is a very useful tool especially for bearing work and for gaging slots. Although a bit expensive, this tool can and has been used as a precision shim. The gage is made of quality tool steel and accurately tapered throughout its entire length. This Taper Gauge must be inserted with the wide flat side. Width 11 mm (7/16 inch) Length 160 mm (6-1/4 inch).
Graduation 1. Side:
0.3 to to 4 mm in 1/20 mm-steps
Graduation 2. Side:
0.010 inches to 0.150 inches in 1/1000 inch-steps
Starrett-no. 270

Code 306470CartPrice € 99.00
You are here:   Homepage   →   Measuring and Marking   →   Taper Gauges