Dieter Schmid's Fine Tools
Veneer Saws

Veneer Saws

Traditional Veneer Saws

The Veneer saw is used to cut veneers, thin sheets of wood from about 0.4 to 0.6 mm, that were cut or peeled off a log by a veneer cutting machine. They are mostly glued to a stable backing material, lumber-cored plywood, ply, particle board, MDF-board or other types of manufactured wood products. Veneer saws are not set! To cut, the veneer is placed on a flat table top made of some wood material and on the cutting line, a ruler, (can be a strip of wood) is attached with clamps. Then the veneer saw is pulled along the ruler, pushing the blade with your left hand against the ruler, and pulling the saw with your right hand.

Veneer Saw made in Germany
Blade length 76 mm
Pitch 1.7 mm/15 TPI
Cuts on pull stroke
Blade has teeth on both sides
Lacquered beech handle
Code 300390CartPrice € 6.95
PAX Veneer Saw
Blade length: 76 mm
Pitch: 1.5 mm/17 TPI
Cuts on pull stroke
Blade has teeth on both sides
Lacquered walnut handle
Made by Thomas Flinn in Sheffield
Code 303012CartPrice € 18.90
KIRSCHEN Veneer Saw
Blade length 76 mm
Pitch 1.5 mm/17 TPI
Cuts on pull stroke
Blade has teeth on both sides
Lacquered beech handle
Code 303999CartPrice € 9.50
Repl. Blade for Veneer Saw
Fits no. 300390, 303999.
Code 300391CartPrice € 3.95
You are here:   Homepage   →   Western Type Saws   →   Veneer Saws