Dieter Schmid's Fine Tools
Center Finding Rules

Center Finding Rules

Precision Steel Rules with "0"-point in the middle

These rules are ideal for finding the center between two points. Mounted on worktables and machines there are unlimited kinds of use. The mm-graduation of these Japanese made steel rules is engraved and reading to left side and right side from the center. They come with a satin chrome finish for better readability and rust resistance.

Note: these center finding steel rules are available with mm-graduation on the upper edge or on the lower edge. Please pay attention to this when ordering!
Steel Rules with "Zero"-point in the middle - mm-graduation on upper edge Enlargement

Steel Rules with "Zero"-point in the middle - mm-graduation on upper edge

Over all dimensions mm right and left from "0" CodePrice
100 x 15 x0.5 mm 50 mm each
Code 310320CartPrice € 23.80
200 x 15 x0.5 mm 100 mm each
Code 310321CartPrice € 31.70
300 x 15 x0.5 mm 150 mm each
Code 310322CartPrice € 33.90
500 x 15 x0.5 mm 250 mm each
Code 310323CartPrice € 49.50
Steel Rules with "Zero"-point in the middle - mm-graduation on lower edge Enlargement

Steel Rules with "Zero"-point in the middle - mm-graduation on lower edge

Over all dimensions mm right and left from "0" CodePrice
100 x 15 x0.5 mm 50 mm each
Code 310330CartPrice € 23.80
200 x 15 x0.5 mm 100 mm each
Code 310331CartPrice € 31.70
300 x 15 x0.5 mm 150 mm each
Code 310332CartPrice € 33.90
500 x 15 x0.5 mm 250 mm each
Code 310333CartPrice € 49.50
You are here:   Homepage   →   Measuring and Marking   →   Rulers, Measering Tapes   →   Center Finding Rules