Dieter Schmid's Fine Tools
Round and Rectangular Bench Dogs, Submersible Bench Hook

Round and Rectangular Bench Dogs, Submersible Bench Hook

Submersible Bench Hook Very useful to fix small workpieces on the top of the bench. Simply mount this bench hook on any edge of a workbench or working table with 2 screws (not included). The jaw is 28 mm wide and 4 mm high. Made of steel, body powder oxide finish. The shaft diameter is 18 mm which makes it possible to use the hook in 19 mm holes (picture below).

Submersible Bench Hook
Clamping height up to 50 mm.
Code 307790CartPrice € 32.00

Submersible Bench Hook
Clamping height up to 75 mm.
Code 307794CartPrice € 33.00
Veritas Traditional Square Bench Dogs Traditional square bench dogs have a rectangular cross section and a side spring.
Solid brass faces avoid damage to sharp edge tools. Best used for new bench construction (due to the angle required for square dog mortises, it is not recommend to use square dogs for retrofitting into an existing bench. Round dogs are best for this purpose).
Shank 5/8 x 3/4 inch (16 x 19 mm)
Overall length 6-3/4 inch (171 mm)
Brass clamping face height 15/16 inch (24 mm)
Brass clamping face width 5/8 inch (16 mm)
Code 308769CartPrice € 49.95
You are here:   Homepage   →   Workshop Equipment   →   Round and Rectangular Bench Dogs, Submersible Bench Hook