Dieter Schmid's Fine Tools

VERITAS Round Bench Dogs



These bench dogs, available in two length, are excellent additions to a new or existing workbench. Simply drill 3/4" (19 mm) holes at regular intervalls through the top of your workbench to turn it into a versatile clamping table. With a rond dog in one of the hole and another in a hole drilled in a wood vise, you can clamp just about any size object to your bench.

above a drawer

The short bench pubs are very useful, when a drawer is under the desk.

instead of side bench dogs

Round short bench pups can also be used for side clamping by drilling holes in the front of your bench. With a round dog in your bench skirt and another in a hole drilled in your end vise, you can secure work to the front of the skirt for side clamping without fumbling for clamps. Make the holes not deeper than 45 mm, to remove the pups without problems.

predrilled block

Use a predrilled block to ensure 90° holes. The dog hole spacing is of your choise.

2° inclined face pulls work down to the bench surface

2° inclined face pulls work down to the bench surface.

Top and side clamping with bench dog and vise.

Top and side clamping with bench dog and vise.

Top and side clamping

Top and side clamping with bench dogs and Wonder Dog clamps

You are here:   Homepage   →   Workshop Equipment   →   Bench Dogs, Bench Hold Down, Pipe Clamps etc.   →   VERITAS Round Bench Dogs