Dieter Schmid - Fine Tools

Dieter Schmid - Fine Tools Georg-Wilhelm-Str. 7 A - 10711 Berlin Tel ++49 30 342 1757 - Fax ++49 30 342 1764 Website: www.fine-tools.com

To prices and other tools

Professional Woodworking Vise Type 53ED With Quick Release Mechanism

How the quick release operates: By turning the handle conterclockwise (CCW) about 1-1/2 to 2 turns, the quick release nut releases the main screw. You can slide the vise open or closed. By turning the handle clockwise (CW) about 1-1/2 to 2 turns, the quick release nut re-engages the main screw and allows you to thighten the vise normally. Warning:Keep your fingers off between the jaws when sliding!

Mounting instructions The jaw mounting surface is 265 mm x 127 mm (10-1/2 in. x 5 in.) wide. Distance of the holes near the jaws: 190 mm (7-1/2 in.) Distance of the rear holes: 175 mm (7 in.) Total length of vise: 605 mm (24 in.) The jaws open 395 mm (15 1/2 in.). Recommended table thickness: 90 mm (3-1/2 in.) If table is thinner, you can add some wood at mounting area only. The vise may be mounted to the underside of a workbench top in any desired location. When positioning, make sure the vise is closed and screw and guide bar do not interfere with any dog holes, drawers, or with the legs of the bench. The vise is designed for a 90 mm (3-1/2 in.) thick bench top. If the bench top is thinner, a board or piece of plywood will have to be inserted between the jaw mounting surface and the underside of the bench top. The vise may be attached with either lag screws (12 x 90 mm or 7/16 x 3-1/2 in.) or through bolts (M12 x 100 mm or 7/16 x 4 in.) with nuts. Countersink the bolt heads! Shop made wooden jaw liners are easily installed using screws after the vise has been mounted. On the rear jaw liner countersink the screws heads to avoid marring work when clamping.