|
|
Dieter Schmid - Fine Tools |
|
Dieter Schmid - Fine Tools
Georg-Wilhelm-Str. 7 A - 10711 Berlin Tel ++49 30 342 1757 - Fax ++49 30 342 1764 Website: www.fine-tools.com |
| To prices and other tools |
Mitre TrimmerThis tool is designed for mitering, beveling and squaring ends of wood. Unlike the mitre box saw which leaves a rough surface, the mitre trimmer cuts with razor sharp knives to shear off the wood for a smooth finish cut. The two gauges, left and right, can be adjusted and locked instantly to any angle from 45° to 90°. Positive pin stops are located at 45° and 90°. Any angle between can be instantly set with thumb screws. All cuts on the trimmer must be made at or near the end of mouldings. Cut-off can be sawed at 45°, slightly over-length. Softwood moulding and trim of small stock can be sawed off square, rough mitered with a chop cut and trimmed with one or two shaving slices. Hardwoods must be sawed at 45°, then trimmed. The harder the wood, the thinner the trim cut. In off-Square joinery, paper thin corrective cuts are made quickly and easily.
The width of workpieces depend on their thickness. The following is possible (example): |
 |
Ideal for end grain chamfering Ideal for the furniture and cabinet maker, picture framer or serious wood craftsmen, this tool can increase skill and greatly reduce the time and cost required to produce quality workmanship. |
|
The mitre trimmer is made of machined cast iron to maintain its accuracy and durability for a lifetime. The 6 mm thick shearing knives are of rugged, heat treated tool steel and can be easliy detached for honing. Warning: Sharp edges! Keep hand away from blades! Keep children away! |
Pin stops at 45°:
|
Pin stops at 90°:
|